lt-mbimcli [OPTION?] - Control MBIM devices
Help Options:
-h, --help
Show help options
--help-all
Show all help options
--help-basic-connect
Show Basic Connect Service options
--help-phonebook
Show Phonebook Service options
--help-dss
Show Device Service Stream options
--help-ms-firmware-id
Show Microsoft Firmware ID Service options
--help-ms-host-shutdown
Show Microsoft Host Shutdown Service options
--help-atds
Show AT&T Device Service options
--help-intel-firmware-update
Show Intel Firmware Update Service options
--help-ms-basic-connect-extensions
Show Microsoft Basic Connect Extensions Service options
Basic Connect options
--query-device-caps
Query device capabilities
--query-subscriber-ready-status
Query subscriber ready status
--query-radio-state
Query radio state
--set-radio-state=[(on|off)]
Set radio state
--query-device-services
Query device services
--query-pin-state
Query PIN state
Enter PUK
--query-pin-list
Query PIN list
--query-home-provider
Query home provider
--query-preferred-providers
Query preferred providers
--query-visible-providers
Query visible providers
--query-registration-state
Query registration state
--register-automatic
Launch automatic registration
--query-signal-state
Query signal state
--query-packet-service-state
Query packet service state
--attach-packet-service
Attach to the packet service
--detach-packet-service
Detach from the packet service
--query-connection-state=[SessionID]
Query connection state (SessionID is optional, defaults to 0)
--connect=["key=value,..."]
Connect (allowed keys: session-id, apn, ip-type (ipv4|ipv6|ipv4v6), auth (PAP|CHAP|MSCHAPV2), username, password)
--query-ip-configuration=[SessionID]
Query IP configuration (SessionID is optional, defaults to 0)
--disconnect=[SessionID]
Disconnect (SessionID is optional, defaults to 0)
--query-packet-statistics
Query packet statistics
--query-ip-packet-filters=[SessionID]
Query IP packet filters (SessionID is optional, defaults to 0)
Phonebook options
--phonebook-delete-all
Delete all phonebook entries
Device Service Stream options
--dss-connect=[(UUID),(Session ID)]
Connect DSS session
--dss-disconnect=[(UUID),(Session ID)]
Disconnect DSS session
Microsoft Firmware ID options
--ms-query-firmware-id
Query firmware ID
Microsoft Host Shutdown options
--ms-notify-host-shutdown
Notify that host is shutting down
AT&T Device Service options
--atds-query-signal
Query signal info
--atds-query-location
Query cell location
Intel Firmware Update Service options
--intel-modem-reboot
Reboot modem
Microsoft Basic Connect Extensions options
--ms-query-pco=[SessionID]
Query PCO value (SessionID is optional, defaults to 0)
--ms-query-lte-attach-configuration
Query LTE attach configuration
--ms-query-lte-attach-status
Query LTE attach status
Application Options:
-d, --device=[PATH]
Specify device path
-p, --device-open-proxy
Request to use the 'mbim-proxy' proxy
-V, --version
Print version
mbimcli 1.18.0 Copyright © 2013-2019 Aleksander Morgado License GPLv2+: GNU GPL version 2 or later <http://gnu.org/licenses/gpl-2.0.html> This is free software: you are free to change and redis‐
tribute it. There is NO WARRANTY, to the extent permitted by law.
SEE ALSO
The full documentation for mbimcli is maintained as a Texinfo manual. If the info and mbimcli programs are properly installed at your site, the command
info mbimcli
should give you access to the complete manual.
mbimcli January 2019 MBIMCLI(1)
Man(1) output converted with
man2html